AUDIO AND VISUAL SYSTEM (for Radio and Display Type) > Data Signal Circuit between Radio Receiver and Stereo Jack Adapter |
for Preparation Click here
DESCRIPTION
The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio and display receiver assembly via this circuit.WIRING DIAGRAM
INSPECTION PROCEDURE
1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
Disconnect the R32 radio and display receiver assembly connector.
Disconnect the N5 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition R32-2 (US1-) - N5-2 (US1-) Always Below 1 Ω R32-3 (US1+) - N5-3 (US1+) R32-2 (US1-) - Body ground Always 10 kΩ or higher R32-3 (US1+) - Body ground
|
| ||||
OK | ||
|