REAR WIPER MOTOR > INSTALLATION |
for Preparation Click here
1. INSTALL REAR WIPER MOTOR GROMMET |
Apply MP grease to the entire inner surface of the wiper motor grommet.
Text in Illustration *1 MP grease - HINT:
- Make sure that grease is applied so that the grooves in the grommet are filled with grease, but not so that the hole of the grommet becomes clogged with grease.
Install the rear wiper motor grommet with the position mark facing upward as shown in the illustration.
Text in Illustration *1 Position Mark
2. INSTALL REAR WIPER MOTOR ASSEMBLY |
Install the wiper motor with the 3 bolts.
- Torque:
- 8.3 N*m{ 85 kgf*cm , 73 in.*lbf }
Connect the connector.
3. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY |
Operate the rear wiper, and stop the rear wiper motor at the automatic stop position.
Clean the wiper pivot serrations with a wire brush.
Text in Illustration *1 Wiper Arm Pivot Serrations *2 Wire Brush *3 Wiper Pivot Serrations
Install the arm and blade with the nut. Make sure that the arm and blade comes to the position shown in the illustration.
- Torque:
- 8.4 N*m{ 86 kgf*cm , 74 in.*lbf }
- HINT:
- Hold down the arm hinge by hand while tightening the nut.
- Install the arm and blade so that the rear wiper blade is aligned with the ceramic line.
Text in Illustration *1 Ceramic Line
Operate the rear wiper while spraying water or washer fluid on the glass. Make sure that there is no interference between the blade and pillar.
Close the wiper arm head cap.
4. INSTALL BACK DOOR TRIM BOARD ASSEMBLY |
Attach the 16 clips to install the back door trim board.
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).