REAR SPEED SENSOR (for 4WD and Pre-Runner) > INSTALLATION |
for Preparation Click here
1. INSTALL SKID CONTROL SENSOR CLAMP |
Install the skid control sensor clamp with the bolt.
- Torque:
- 32 N*m{ 326 kgf*cm , 24 ft.*lbf }
- NOTICE:
- Make sure the clamp rotation stopper touches the installation position.
2. INSTALL REAR SPEED SENSOR RH |
Install the speed sensor with the bolt.
- Torque:
- 8.5 N*m{ 87 kgf*cm , 75 in.*lbf }
- NOTICE:
- Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
- While inserting the speed sensor into the axle housing hole, do not strike or damage the sensor tip.
- After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the axle housing.
Attach the 6 clamps.
- NOTICE:
- When attaching the clamps, do not twist the wire harness.
Connect the connector.
- NOTICE:
- Pass the sensor connector between the brake tube and axle housing before connecting it to the wire harness connector on the vehicle.
- Securely connect the connector.
- When connecting the connector, do not twist the wire harness.
Attach the connector to the skid control sensor clamp.
3. INSTALL REAR SPEED SENSOR LH |
Install the speed sensor with the bolt.
- Torque:
- 8.5 N*m{ 87 kgf*cm , 75 in.*lbf }
- NOTICE:
- Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
- While inserting the speed sensor into the axle housing hole, do not strike or damage the sensor tip.
- After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the axle housing.
Attach the 3 clamps.
- NOTICE:
- When attaching the clamps, do not twist the wire harness.
Connect the connector.
- NOTICE:
- Securely connect the connector.
- When connecting the connector, do not twist the wire harness.
Attach the connector.
4. INSTALL REAR WHEEL |
- Torque:
- 105 N*m{ 1071 kgf*cm , 77 ft.*lbf }
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
6. CHECK SPEED SENSOR SIGNAL |
w/ Rear Differential Lock:
Check the speed sensor signal (Click here).
w/o Rear Differential Lock:
Check the speed sensor signal (Click here).