DTC C1251/51 Open in Pump Motor Circuit |
for Preparation Click here
DESCRIPTION
The ABS pump motor is located inside the brake actuator.DTC No. | DTC Detection Condition | Trouble Area |
C1251/51 | When one of following conditions is met:
|
|
WIRING DIAGRAM
INSPECTION PROCEDURE
1.CHOOSE DIAGNOSIS METHOD |
Choose the diagnosis method.
Method Method Proceed to Using intelligent tester A Not using intelligent tester B
|
| ||||
A | |
2.PERFORM ACTIVE TEST BY INTELLIGENT TESTER (ABS MOTOR RELAY) |
Select the Active Test, generate a control command, and then check that the ABS motor relay operates.
Item | Vehicle Condition / Test Details | Diagnostic Note |
ABS Motor Relay | Turn ABS motor relay ON / OFF | Operation sound of motor can be heard |
- OK:
- Operation sound of ABS motor is heard.
|
| ||||
NG | |
3.CHECK WIRE HARNESS (SKID CONTROL ECU - BATTERY AND BODY GROUND) |
Disconnect the S2 ECU connector.
Measure the resistance of the wire harness side connector.
- Standard resistance:
Tester Connection Specified Condition S2-2 (GND1) - Body ground Below 1 Ω S2-24 (GND2) - Body ground Below 1 Ω
Measure the voltage of the wire harness side connector.
- Standard voltage:
Tester Connection Specified Condition S2-23 (+BM) - Body ground 10 to 14 V
|
| ||||
OK | ||
|