STEERING LOCK SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Perform troubleshooting in accordance with the following flowchart.
  1. *: Use the Techstream.


1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V
      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

    NEXT


    3.CHECK AND CLEAR DTCs*

      NEXT


      4.PROBLEM SYMPTOM CONFIRMATION

        Result:
        Result
        		Proceed to
        Symptom does not occur.
        		A
        Symptom occurs.
        		B


      		B.
      Go to step 6
      A


      5.SYMPTOM SIMULATION

        NEXT


        6.CHECK CAN COMMUNICATION SYSTEM*

          HINT:
          Check that there are no problems in the CAN communication system before troubleshooting of the steering lock system.

        NEXT


        7.DTC CHECK*

        1. Check for DTCs (Click here).

          Result:
          Result
          		Proceed to
          DTC is output.
          		A
          DTC is not output.
          		B


        		A.
        Go to step 9
        B


        8.PROBLEM SYMPTOMS TABLE

          Result:
          Result
          		Proceed to
          Fault is not listed in problem symptoms table.
          		A
          Fault is listed in problem symptoms table.
          		B


        		B.
        Go to step 10
        A


        9.DTC CHART

          NEXT


          10.CIRCUIT INSPECTION*

            NEXT


            11.PROBLEM IDENTIFICATION

              NEXT


              12.REPAIR OR REPLACEMENT

                NEXT


                13.CONFIRMATION TEST*

                  NEXT

                  END