ENGINE IMMOBILISER SYSTEM (w/ Smart Key System) > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
  1. Connect the Techstream to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / Smart Key / Data List.

  5. Read the Data List according to the display on the Techstream.


Smart Key (Certification ECU (Smart Key ECU Assembly)) 
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Ignition Switch
Engine switch on (IG) signal / ON or OFF
ON: Engine switch on (ACC, IG) or engine started
OFF: Engine switch off
-
ACC Switch
Engine switch on (ACC) signal / ON or OFF
ON: Engine switch on (ACC, IG) or engine started
OFF: Engine switch off
-
Immobiliser
Immobiliser system status / SET or UNSET
SET: Key is not in cabin
UNSET: Key is in cabin
-
Master Key
Master key code signal / MATCH or NO MATCH
MATCH: Master key code is sent
NO MATCH: Unmatched master key code is sent
-
Sub Key
Sub-key (Master key) code signal / MATCH or NO MATCH
MATCH: Sub-key (master key) code is sent
NO MATCH: Unmatched sub-key (master key) code is sent
-
BCC Malfunction
Transponder chip signal / OK or NG
OK: Correct data sent
NG: Incorrect data sent
-
Abnormal Status
Transponder chip data / OK or NG
OK: Data OK
NG: Data error
-
Different Encrypt Code
Transponder chip signal / OK or NG
OK: Correct data sent
NG: Incorrect data sent
-
Different Serial Number
Transponder chip signal / OK or NG
OK: Correct data sent
NG: Incorrect data sent
-
Frame Error
Transponder chip signal / OK or NG
OK: Correct data sent
NG: Incorrect data sent
-
Response
Transponder chip signal / OK or NG
OK: Correct data sent
NG: Incorrect data sent
-

ACTIVE TEST

HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
  1. Connect the Techstream to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / Smart Key / Active Test.

  5. Perform the Active Test according to the display on the Techstream.


Smart Key (Certification ECU (Smart Key ECU Assembly)) 
Tester Display
Test Part
Control Range
Diagnostic Note
Security Indicator
Security indicator light
ON/OFF
-